PDA

View Full Version : Linux Compatibility: Via Via Rhine Network Adapter


phoronix
04-13-2007, 09:24 AM
This is an entry for Phoronix LCH (http://www.phoronix.net/forums/showthread.php?p=6635#post6635). Feel free to comment on the Linux compatibility for the Via Via Rhine Network Adapter in this thread.

Via Via Rhine Network Adapter



Description: Via Rhine 10/100Mbit network adapter onboard
Hardware Notes: Works well under all linux distros haven't had any problem so far.

lspci -v
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 78)
Subsystem: Micro-Star International Co., Ltd. Unknown device 7095
Flags: bus master, medium devsel, latency 32, IRQ 193
I/O ports at e900 [size=256]
Memory at e3012000 (32-bit, non-prefetchable) [size=256]
Capabilities: [40] Power Management version 2

lshw
*-network:1
description: Ethernet interface
product: VT6102 [Rhine-II]
vendor: VIA Technologies, Inc.
physical id: 12
bus info: pci@00:12.0
logical name: eth0
version: 78
serial: 00:0c:76:ae:a6:8e
size: 100MB/s
capacity: 100MB/s
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegociation
configuration: autonegociation=on broadcast=yes driver=via-rhine driverversion=1.2.0-2.6 duplex=full ip=***.***.***.*** link=yes multicast=yes port=MII speed=100MB/s
resources: ioport:e900-e9ff iomemory:e3012000-e30120ff irq:193