This is an entry for Phoronix LCH. Feel free to comment on the Linux compatibility for the IBM Deskstar 180GXP in this thread.

IBM Deskstar 180GXP



Description: Hard drive with 30, 60, 80, 120 or 180 GB capacity, IDE interface and 2 or 8 MB cache. Later drives manufactured by Hitachi Global Storage Technologies (HGST).
Hardware Notes: Rotational Speed 7200 RPM, Interface standard ATA-6, Average seek time 8.5 ms. Notable features include: Fluid dynamic bearings (FDB), load-unload ramp, Tagged Command Queuing (TCQ), Drive Fitness Test (DFT), temperature monitoring, TrueTrak servo and No-ID sector formatting.

hdparm -I
ATA device, with non-removable media
powers-up in standby; SET FEATURES subcmd spins-up.
Model Number: IC35L090AVV207-0
Serial Number: VNVC02G3G1WYYG
Firmware Revision: V23OA63A
Standards:
Used: ATA/ATAPI-6 T13 1410D revision 3a
Supported: 6 5 4 3
Configuration:
Logical max current
cylinders 16383 65535
heads 16 1
sectors/track 63 63
--
CHS current addressable sectors: 4128705
LBA user addressable sectors: 160836480
LBA48 user addressable sectors: 160836480
device size with M = 1024*1024: 78533 MBytes
device size with M = 1000*1000: 82348 MBytes (82 GB)
Capabilities:
LBA, IORDY(can be disabled)
bytes avail on r/w long: 52 Queue depth: 32
Standby timer values: spec'd by Standard, no device specific minimum
R/W multiple sector transfer: Max = 16 Current = 0
Advanced power management level: unknown setting (0x0000)
Recommended acoustic management value: 128, current value: 254
DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* NOP cmd
* READ BUFFER cmd
* WRITE BUFFER cmd
* Host Protected Area feature set
Release interrupt
* Look-ahead
* Write cache
* Power Management feature set
Security Mode feature set
* SMART feature set
* FLUSH CACHE EXT command
* Mandatory FLUSH CACHE command
* Device Configuration Overlay feature set
* 48-bit Address feature set
* Automatic Acoustic Management feature set
SET MAX security extension
Address Offset Reserved Area Boot
SET FEATURES subcommand required to spinup after power up
Power-Up In Standby feature set
Advanced Power Management feature set
* READ/WRITE DMA QUEUED
* General Purpose Logging feature set
* SMART self-test
* SMART error logging
Security:
Master password revision code = 65534
supported
not enabled
not locked
not frozen
not expired: security count
not supported: enhanced erase
46min for SECURITY ERASE UNIT.
HW reset results:
CBLID- above Vih
Device num = 0 determined by the jumper
Checksum: correct